Close or replace the access panel, then secure it with thumbscrews, if any are present. Remove or open the access panel. Locate the cdrom entry in the list of mapped devices, and change to the device by entering its associated fs number for example, fs0 under UEFI Shell prompt. Retrieving firmware version, this may take several minutes. Go to the Business Support Center, at:
|Date Added:||6 August 2005|
|File Size:||51.71 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Update the controller firmware, if necessary. Update the system firmware on the server, if necessary. Save the retaining screw, if one is present. To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to cool before touching them.
Boot the server to HP-UX. Back up all necessary data before deleting the logical drive. The firmware image file and saupdate.
Use conductive field service tools. Review the installation procedures below before performing any installation. F3 to delete the logical drive.
Power on the external storage devices. Many servers are capable of providing energy levels that are considered hazardous and are intended to be serviced only by qualified personnel who have been trained to deal with these hazards. Power on the peripheral devices and storage devices. Retrieving firmware version, this may take several minutes. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services.
Power off any peripheral devices.
If the cable that you need is not listed here, or if you need additional ordering information, see the HP website at: Smart Array P controllers require version B. A percent sign represents the C shell system prompt.
HP P410 IT mode
Go to the Business Support Center, at: From the main menu, you can use ORCA to create, view, or delete logical drives. Verifying external disk enclosure connections Use saupdate from the UEFI Shell to verify the external disk sakpdate.efi connected to the Smart Array controller. Saupdate.rfi update the controller firmware with saupdate, follow these steps: Locate the cdrom entry in the list of mapped devices, and change to the device by entering its associated fs number for example, fs0 under UEFI Shell prompt.
If more than 32 logical drives are defined, a warning appears indicating that the number of logical drives that can be handled by ORCA has been exceeded. Valid license from HP required for possession, use or copying.
SATA support will be added in a future firmware update.
HP 서버 RAID 기능 풀기
This document provides a generic procedure using a Smart Array Pi controller as an example. Reconnect the peripheral devices and the AC power supply to the server.
Check the installation prerequisites. Querying or changing modes is not supported for other controllers. Place the Offline Diagnostic CD containing saupdate. The first is at segment 1, bus 71, device 0, function 0.
Many of these POST messages are self-explanatory and suggest corrective actions for troubleshooting. WARNING A warning calls attention to important information that if not understood or followed will result in personal injury or nonrecoverable waupdate.efi problems.